Answer this Question (4 Answers)

• We have just replaced the catch on our Cannon Carrick C60GCSI . The whole hob top does not have to come off. Take the fascia off in the manner described above and undo the screws for the back panel, on the same side as the side panel, so that the side panel can be brought slightly away from the side. Slide a rag or something similar between the side panel and the area near the catch so that you won't get your fingers crushed and replace the catch. If you search for 'take side panel off a Cannon cooker' there is a photographic step by step guide which somebody has put on the internet. It is far more helpful than Cannon. By J - - 30 July 2018
• I fitted a new roller catch to a Cannon C60DTXF; absolutely no problem to anyone who can use a screwdriver. Definitely best to remove the hob but no need to take the whole side panel off, plenty of room to get at the catch with just the front screws removed and the side panel held open. Beware of extremely sharp panel edging, one bit of which sliced into my right digit finger!! By Brian - Wiltshire - 08 May 2016
• I fitted the catch to a Cannon C60GPXF. You need to pull off all the knobs & buttons from the fascia. Remove two screws at the bottom and slide the fascia to the left before sliding it down and off. Remove the screws holding the hob top at the front. Remove the screws on the right holding the top of the right side panel and the three screws further down the front of the side panel. Remove the security screws holding the bumpers at the back of the hob top. You are now able to lift the hob top slightly and the right side panel will ease out far enough to undo the front screws for the Roller Catch and replace it. I removed the hob top completely by removing the screws around the burners, but I do not think that this is strictly necessary. By Chris - Southend-on-Sea - 19 September 2015
• 

  Chris at eSpares says...

  We think the hob surround may have to be removed to fit this part.