Washer Dryer Main PCB Stock Number: ES1777863
Genuine spare part for select models of Beko washer dryers
Manufactured by Beko
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Washer Dryer Main PCB
If your washer is refusing to function due to a faulty control board! Look no further as eSpares may just have the spare part for you. With this replacement module fitted to your washer, you can let the washer dryer do all the hard for you while you relax with a cuppa!
Genuine spare part for select models of Beko washer dryers.
Please check the suitable model fit list to ensure that this is the correct part for your appliance.
4 Questions and 4 Answers
My two year old Beko WDR7543121W washing machine powered off during a drying cycle and won't power back on. I've tried some fixes like replacing the fuse, checking the mains plug, outlet etc etc to no success. I've seen one review which matches my issue and was wondering how easy it is to replace the PCB which I suspect may be the issue.
-
Parminder at eSpares says...
We believe replacing a PCB should be a fairly straight forward process for someone who has general DIY knowledge. We recommend taking pictures of the wires so that you can rewire accurately.
This is gonna sound stupid but does this contain the entire PCB unit or is this just the plastic outer case? 1 Answer
-
eSpares Staff at eSpares says...
This item is the PCB and not just the plastic case.
if I fit this unit my self to wdr7543121w is it a straight swop over or do you need to any engineers set up codes 1 Answer
Beko washer dryer model wdr7543121w clothes coming out warm wet due to much water being put in and not drained in a drying cycle Checked already the heater element it ok ,cleaned fan and heater box and condenser of lint .None of tocs have tripped tested with meter. Pump checked and sump and drain hoses all clear ,wash cycles all fine just drying cycle seems out of sync ,Water inlet opens and closes to condenser no leak past and I am given to believe that this action should be intermittent on this model to save water any guidance would be appreciated I’ve also considered the linear level switch? No support available from Beko technical infact they were rude and abrupt so I might just cut my losses and junk it when the washer dies So much for saving the environment I had a hotpoint washer dryer for over twenty years their tech girls were only to happy to help and were proud the machine was still going
-
eSpares Staff at eSpares says...
On a washer dryer, there is usually a dual inlet valve and it is likely the dryer valve is letting in too much water so check that and make sure the condenser is not blocked.
Will this part fit my appliance?
Check Now
