Single Pole Grill Cut Out Microswitch Stock Number: ES836014
Genuine spare part for select models of Ariston, Creda and Hotpoint cookers
Manufactured by Indesit
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Single Pole Grill Cut Out Microswitch
If the cut-out microswitch for your grill is damaged, it can cause your appliance to suddenly stop functioning. Don't panic because help is on hand. eSpares has the perfect solution for you which could be the just the part to get your cooker back up running.
Genuine spare part for select models of Hotpoint, Creda and Indesit cookers.
Please check the suitable model fit list to ensure that this is the correct part for your appliance.
6 Questions and 5 Answers
-
eSpares Staff at eSpares says...
The microswitch is located on the outside of the oven on the right-hand side, it is held in by screws that secure it to the cavity.
I recently purchased a new lamp holder from yourselves because I changed the bulb & as I tightened the bulb it arked/sparked. May I say brilliant service, but since this has been replaced the fan will not turn off. The cooker itself seems to be working fine but need to turn main power of to stop the fan. Have you got any advise what part is now at fault. Many Thanks Paul & Su Bradford
-
Dean at eSpares says...
Depending on the model there may be 2 fans in the oven, this may indicate a switch or thermostat issue, please refer to our video for more help www.youtube.com/watch?v=_lWk22-qvoI
-
Chris at eSpares says...
If the switch has Three connections as shown in the picture it is a two way switch. The two wires should be connected across the N O and COM connections as these will close when the door is closed to turn the light on. Fit between the N C and COM to light when the switch is not pressed.
-
Chris at eSpares says...
It is usually necessary to remove the top and back panels to release the sides. The side panels may have additional screws through the door surround at the front that may also need removing.
The same question as the previous one please - how do I get to the old door switch to replace with new one? I could logically give it a go but sense it would be better to go ahead with instructions! Thank you very much :o) :o) :o) 1 Answer
-
Chris at eSpares says...
It is necessary to remove the right side cover to access this switch. To remove the cover you may have to loosen the hob top and move it to one side.
Will this part fit my appliance?
Check Now
